Differences

This shows you the differences between two versions of the page.

--- projects:diytig:menu [2022/06/09 18:11] – spsmith
+++ projects:diytig:menu [2022/09/30 23:28] (current) – spsmith
@@ Line 2: / Line 2: @@
 === Menu System ====
-- **Amperage Control**
+- **[[projects:diytig:menu:amps|Amperage Control]]**
-  * Max Amps
+  * //Max Amps//
     * 10 - 200 amps
-  * Start Amps
+  * //Start Amps//
     * 10 - 200 amps
-  * Up Slope
+  * //Up Slope//
     * Amps/Second
-  * Down Slope
+  * //Down Slope//
     * Amps/Second
-  * End Amps
+  * //End Amps//
+    * 10 - 200 amps
-- **Gas Solenoid**
+- **[[projects:diytig:menu:solenoid|Gas Solenoid]]**
-  * Pre Flow
+  * //Pre Flow//
-    * 0 - 1 seconds
+    * 0/1 seconds
-  * Post Flow
+  * //Post Flow//
     * 1 - 10 seconds
-- **Pulse Weld**
+- **[[projects:diytig:menu:pulseweld|Pulse Weld]]**
   * //Pulse Rate//
     * 1 - 50 per second
-  * Background Amps
+  * //Background Amps//
     * 10 - 200 amps (limited by Max Amps value)
-  * Pulse Width
+  * //Pulse Width//
     * 1 - 99%
-  * Peak Pulse Amps
+  * //Peak Pulse Amps//
     * Background Amps value  to  Max Amps value
-- **Frequency (AC)**
+- **[[projects:diytig:menu:frequency|Frequency (AC)]]**
   * 50 - 200Hz
-- **A/C Balance**
+- **[[projects:diytig:menu:acbalance|A/C Balance]]**
   * 100%EN - 0 - 100%EP
-- **AC/DC**
+- **[[projects:diytig:menu:acdc|AC/DC]]**
-  * AC
+  * //AC//
-  * DC
+  * //DC//
     * DCEN
     * DCEP
-- **High Voltage/High Frequency**
+- **[[projects:diytig:menu:hvhf|High Voltage / High Frequency]]**
-  * On
+  * //On//
-  * Off
+  * //Off//
-- **Process Type**
+- **[[projects:diytig:menu:process|Process Type]]**
-  * TIG
+  * //TIG//
     * 4T
     * 2T
-  * Stick
+  * //Stick//
-  * Pulse
+  * //Pulse//
     * On
     * Off
+- **[[projects:diytig:menu:house|House Keeping]]**
+  * Factory Reset
+  * Time(?)